How to make a DIY pineapple water bong

Published Jul 14, 2019 10:36 a.m. ET
Reddit / u/420AlbertHofmann420

Looking for a new and exciting way to try smoking marijuana? Or maybe you are searching for a project for an edible bong building competition. No matter what your reason is for being here, we promise you won’t leave disappointed. If you have tried other versions of edible bongs like the strawberry weed pipe, watermelon bong, and banana pipe, then you already know what a treat that smoking cannabis through fruit can offer. This DIY project provides both the excitement and simplicity of a weed pipe while also coming equipped with a bubbler water feature to keep your smoke fresh and enjoyable, and the best part is the whole thing can be done for under $10 which makes it an affordable and environmentally friendly option.

Materials you will need

  • 1 pineapple (any size)
  • 1 large sharp knife
  • 1 narrow, sharp knife
  • 1 arm’s length of rubber tubing (amount needed will vary depending on the size of the pineapple)
  • 1 spoon

Instructions

  1. To begin, you will need to make an even slice and remove the top portion of the pineapple approximately two or three inches below the leaves.

  2. Set the pineapple top aside and use a large knife to make a criss-cross incision into the fruit center, and around the edges of the fruit casing. This will make it easier to remove the fresh pineapple with minimal effort.

  3. Use a spoon to scoop out the middle of the pineapple. It doesn’t have to be perfectly clean but should be cleared enough to hold at least a cup water.

  4. Once the chamber is large enough, rinse out the pineapple with water to remove any loose debris.

  5. Now use a sharp and narrow knife to pierce a hole into the side of the pineapple, right in the middle that the tubing will fit into snugly. This opening will act as the escape for the smoke to travel through the water.

  6. Cut a portion of rubber tubing that is long enough to comfortably draw from, while also able to reach the bottom of the pineapple once it’s fed through your freshly drilled hole.

  7. Set the pineapple base aside and turn your attention to the lid. It’s time to drill one hole into one side of the cap that is wide enough for the second piece of tube to fit snugly into.

  8. Feed the tube into the hole. This one should be long enough to dangle into the pineapple chamber, but not touch the bottom. It should also be long enough outside of the bong lid that you can comfortably draw on it.

  9. Close the top of your freshly made bubbler bong and check the draw by sucking on the lower tube. If it’s challenging to draw from, you might need to widen the holes, so they aren’t collapsing the rubber. Once you are satisfied with the bong’s airflow, you can move onto how to use a pineapple bong.

How to use a pineapple water bong

WW

By this point, you have likely noticed that your newly made pineapple bong has no bowl. This is because it is meant to be used with a joint instead, which only requires a stem to work correctly.

Materials needed

  • 1 cup of cold water
  • 1 gram of cannabis (approximately)
  • 1 marijuana rolling paper
  • 1 joint filter
  • 1 weed grinder

Instructions

  1. Fill the pineapple chamber approximately halfway with fresh cold water.

  2. Use a weed grinder to prepare the cannabis to be rolled.

  3. Fill a marijuana rolling paper with enough herb that it will snugly fit into the tubing on the bong.

  4. Install the filter, roll the joint, and fasten the glue strip edge with moisture.

  5. Stuff the filtered end of the joint into the tubing that comes out of the side of the water bong.

  6. Light the end of the rolled joint, and inhale through the tube piece that protrudes from the lid.

Best weed strains for a pineapple water bong

The pineapple is full of sweet and sour flavors that can also be found in marijuana strains. There are also other fruity additions that when combined with this pineapple bong will release a fruit explosion that just makes the whole experience that much better. To help you out, here are a few sweet, sour, and fruity cannabis strains that are complemented and enhanced by the addition of fresh pineapple juice.

  • Green Crack
  • Strawberry Cough
  • Pineapple Express
  • Lemon Haze
  • Agent Orange
  • Strawberry Banana
  • Tangie
  • Amnesia Haze
  • Glass Slipper
  • Pineapple Trainwreck
  • Strawberry Kush
  • Lemon Skunk
  • Tangerine Dream
  • Pink Champagne
  • Chernobyl
  • Orange Kush
  • Kandy Kush
  • Strawberry Cheesecake
  • Pineapple Diesel
  • Ghost OG
  • Juicy Fruit
  • Dairy Queen
  • Liberty Haze
  • Orange Cookies
  • Paris OG
  • Hawaiian Dream
  • East Coast Sour Diesel
The easiest way to make an apple bong at home
WW
0
0 reviews
Write your review

Author

Related posts